We recently purchased some of the ESW-540 Cisco switches for some lower end access ports. I'd like to script the configuration backup using Kiwicat if possible, but haven't figured out how to either get into the cli, or config kiwicat to backup via webui.
With the SRW Linksys line you could hit ctrl-z and type lcli to get into the cli interface.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...