SF200-24P web management is not accessible after firmware upgrade
Hello. Trying to add SNMP support to the switch I attempted a FW upgrade. The process seemed to complete succesfully but after that I have been unable to access the web management.
I can access the web management login and introduce the username and password but after that it just freezes with a pop up stating "Processing data 70%"
I have tried reseting the switch to factory defaults by pressing the reset button for more than 10 seconds but although the pasword went back to the factory default value, I can't still access the web management (the exact same problem)
Is there any work-aroud to make sure EVERYTHING is set back to factory defaults?
Cannot Add a New Switch to an Existing Stack
Stacking is a network solution that connects two or more switches on top of one another and configuring them as one device. The switches in a stack function as a single switch...
Configure the PNP Settings on a Switch
The installation of new networking devices or replacement of devices can be expensive, time-consuming, and error-prone when performed manually. Typically, new devices are first sent to...
SG350X, Sx550X: RSPAN Mirrored Packet Loss when Forwarding
February 12, 2017