Im about to buy a new Gigabit switch, and i really like the SG300-10.
My question is, is there a CLI on this box? or is it pure webmanagement?
I will be using it for:
Can i do this from the CLI?
I will be using this for my home setup... and im having 2 Servers (running VMWare) and approx 20 VHosts.
Will this switch be able to handle the traffic? right now im stucked with a 2960 24 ports, but its only 100Mbit ports, and i really need some more performance now for migrating Vhosts and transferring large files.
GRVP, if I recall from a youtube vid I watched a few days ago is the predecessor to VTP, not Cisco propietary like VTP either. I wouldn't bet the farm based on anything I say though cuz I have very limited experience.
[toc:faq]Introduction: This document describes how to connect SG300 with
Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The specification for STP is
IEEE 802.1D. The main purpose of STP is to e...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...