Thank you for reaching the Small Business Support Community.
It's been several days since you posted your request for support with no answer from any of the community members yet, I therefore suggest you to contact the Small Business Support Center directly to have an engineer assist you on this matter, I personally doubt you can save the configuration via SNMP and I found no similar or related cases or information about it.
[toc:faq]Introduction: This document describes how to connect SG300 with
Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The specification for STP is
IEEE 802.1D. The main purpose of STP is to e...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: