Hi Boris, it looks like the macros are jacked up. A lot of the ports say dynamic-type unknown and a ge-1 link says switch no switch over and over. I'm not sure what happened to that switch during installation / configuration but it seems like a lot of trial/error there which may cause the macros to get messed up.
I'd personally default the switch and put a clean configuration there. There shouldn't be any convoluted macro entries.
-Tom Please mark answered for helpful posts
Please mark answered for helpful posts
Cannot Add a New Switch to an Existing Stack
Stacking is a network solution that connects two or more switches on top of one another and configuring them as one device. The switches in a stack function as a single switch...
Configure the PNP Settings on a Switch
The installation of new networking devices or replacement of devices can be expensive, time-consuming, and error-prone when performed manually. Typically, new devices are first sent to...
SG350X, Sx550X: RSPAN Mirrored Packet Loss when Forwarding
February 12, 2017