Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SF300 CLI - How to change IP, with L3 enabled ?

Hello,

I have a SF300-48P (Firmware 1.0.0.27).

I wanted to enable L3, and the configuration was renewed (OK, I knew that).

Then, I'm not able to modify the IP : I set it to static, and it kept the IP provided by the DHCP.

There is no way to modify this management IP via the GUI.

I enabled Telnet (SSH cannot be enabled...) and connected via Putty.

But, I have a menu (not the CLI), and I'm not able to change the IP via that menu (error : duplicate IP).

And I cannot obtain the CLI, even when typing Ctrl-Z.

How can I :

- Modify the IP, with L3 enabled

- Have access to the CLI

Thanks in advance for your help.

3 REPLIES
Bronze

SF300 CLI - How to change IP, with L3 enabled ?

Hi

Command line:

switch#config

switch(config)#int vlan 1

switch(config)#ip add 192.168.20.5 255.255.255.0

Try this

New Member

SF300 CLI - How to change IP, with L3 enabled ?

Hi, thanks for this answer.

I know that I have to execute this command in the CLI, however the problem is the access to the CLI.

When connecting with telnet, I have a menu, but not the CLI itself.

And I don't know how to switch from this menu to the CLI (Ctrl-Z doesn't work).

Green

SF300 CLI - How to change IP, with L3 enabled ?

Please update the firmware. Cli was not available on this release.

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
812
Views
5
Helpful
3
Replies
CreatePlease login to create content