I have had the misfortune to have never run into a SF300-48 before recently. It is a doozy of a CLI and GUI. I can't seem to get my ShoreTel phones and LAN working simultaneously and the configuration of this device is counter to all of my CCNA studies. If I'm accurate in my thinking, all of my ports need to be trunk ports to allow DHCP to do it's thing for both VLANs (VOICE, and DATA)
I've tested DHCP for both VLANS but it will only work for one at a time. The DHCP Server is the other end of the trunk on port Gi4. Any help would be greatly appreciated.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...