Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

sf300 with full commands?

Hello!

I am finish my ccna trainnig and made my ccna test with success.

So, I receive a mission to configure the sf300-48p, but this model dont have all commands and dont have all settings of show run. This model is very different of normal, dont have IOS, bur .ros.

So, have a way to change this configs to normal mode? Normal as full ios features, show run complete, erase... and other things? thanks!

2 REPLIES
Green

sf300 with full commands?

Hi Pedio, this is not an IOS device which also means there is not an "IOS on/off switch". If you need command reference, please use the following-

http://www.cisco.com/en/US/products/ps10898/prod_command_reference_list.html

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

sf300 with full commands?

Hello,

An alternative solution is to use the web configuration utility of the switch rather than the CLI. For help with this, you can use the Guide Me tool to look up many configuration and troubleshooting articles.

I hope this helps!

Alex

680
Views
0
Helpful
2
Replies
CreatePlease to create content