Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SF302 - Voice and VLAN Config

Picked up an 8 port SF302 on the fly to replace a 2960 that has failed. Attempting to config for use with DATA and VOICE vlans.

Device port G1 is connected to 0/1 on a 2911, which has 2 sub-interfaces- 1 each for voice and data.

Cannot get switch to put IP's from Router or ping router from the switch. This seems like it should be a pretty basic config. Any help would be greatly appreciated!    

I've reset the switch to defaults agian, so a quick step by step wouldn't hurt.    

512
Views
0
Helpful
0
Replies