Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SFE/SGE IPv6 support.


I'd like to know if Cisco SFE 2000 supported IPv6.

Because the datasheet doesn't have any information about it. Link reference:

However the same product family SFE2010 have support for IPv6. Link reference:

I saw administration guide and it have all information about IPv6. Link reference:

Can anybody help me with it information?

Thank you!


Ronaldo Barbieri


Re: SFE/SGE IPv6 support.

Hi Ronaldo,

When the SFE/SGE series products went to version 3 of the firmware we saw much better support for VLAN and other features such as IPv6.  That might account as to why admin guides were missing content on IPv6 as they may have been references for Version1 firmware and not version 3 firmware.

All SFE/SGE's now support version 3 code.

If you do not need the stacking support from the SGE/SFE series  why not look seriously at the lower cost SG300 and SF300 series.

Very good IPv6 functionality built in these units, see following URL on the new SG300/SF300 series. (this family is really a refresh of Silicon/Operating system and packaging of the older SRW series.

Also if there is a failure of the new SG300/SF300 series switch, the support center will forward replace the unit for next business day delivery, where applicable.

hope this is of use,

regards Dave

CreatePlease login to create content