I am just looking for a clue to switch back the active image to the good one, but I don't have a chance cause it is an intermediate image from a software upgrade and there is no possibility in the CLI because of the continuous reboots.
Configure the PNP Settings on a Switch
The installation of new networking devices or replacement of devices can be expensive, time-consuming, and error-prone when performed manually. Typically, new devices are first sent to...
SG350X, Sx550X: RSPAN Mirrored Packet Loss when Forwarding
February 12, 2017
SG350X: Running Cable Test Via The "Test Cable-Diagnostics Tdr" Command May Provide Unpredictable Results
May 23, 2017