Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SG 200-08 CNA community error output for /exec/show/ver/CR not found

I am trying to add a cisco 8-port gigabit smart switch SG 200-08 to our existing CNA community and getting an error when discovering the device by ip.  Does anyone know how to get around this? I have attached a screen shot.

Thanks in advance for any advice.

Shannon

3 REPLIES
Green

SG 200-08 CNA community error output for /exec/show/ver/CR not

Hi Lauren,

The device is not designed to work with CNA. If it does discover, it would have limited to no ability.

-Tom

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
Community Member

But the documentation says,

But the documentation says, that SG200-08 is supported by CNA from version 6.1.0 (http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_network_assistant/version6/relnotes/ol32368.pdf).

Attached picture is dated to 2016/12/01, CNA version is 6.3.
Switch's Firmware version is 1.0.8.3

I don't know, where is problem.

Dan

Cisco Employee

Hello SBDKrusnohor

Hello SBDKrusnohor

Note that this post was about 4 years ago. So this release in April 2016 release provides support. Do you have any specific questions on CNA?

Thanks

Glenn

540
Views
0
Helpful
3
Replies
CreatePlease to create content