We have recently purchased SG 300-52Port Cisco Switch to support our Network but they constantly having some bizarre issues or I assume bugs, i.e. we cannot Telnet nor SSH to the switch now, whereas we were able to SSH before, we have set them up for Remote Log Services to get some syslogs and reports but no report have been generated nor logs,
I have done some testing through Wireshark and there are absolutely no reports / logs.
We have some real issues with this switch and it’s hard to believe that this is a Cisco Product,
SG 300-52 Port Gigabit Managed Switch
Firmware Version (Active Image ) : 220.127.116.11
Firmware Version (Non-active ) : 18.104.22.168
Boot Version : 22.214.171.124
It would be appreciated if someone could shed some light so that we could fix these issues.
With the other problems you have described, I would certainly try to do the reflash and backup. If you continue to have problems like this afterward, I would recommend giving us a call here at the support center. I will add the link just in case.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: