10-08-2013 11:29 AM
Hello
I have a very simple question about CLI on SG-300. How to display trunk ports via cli? I have switch with 28 ports and I wanted to see what switchport mode is applied to every port - or simply we can just focus on trunk ports. On Cisco Catalysts there is "show trunk" command in order to get list of ports in Trunk mode. Is there any way to do it on SG-300?
srv-sw-1#show version
SW version 1.3.0.62 ( date 02-May-2013 time 14:55:01 )
Boot version 1.1.0.6 ( date 11-May-2011 time 18:31:00 )
HW version V02
thank you
michal
10-08-2013 04:33 PM
Hi Michal, this is a good point. I also do not know a command outside of show run for this. I do not believe there is one.
-Tom
Please mark answered for helpful posts
10-10-2013 05:43 PM
Hi,
I remember something at least that works port by port:
>#sh int switchport fa 1
Port : fa1
Port Mode: Trunk
Gvrp Status: disabled
Ingress Filtering: true
Acceptable Frame Type: admitAll
Ingress UnTagged VLAN ( NATIVE ): 1
Port is member in:
Vlan Name Egress rule Port Membership Type
---- -------------------------------- ----------- --------------------
1 1 Untagged System
Displays detailed info about each port, range command will not work, but it's something.
You can check for vlans and or tags with:
sh vlan
sh vlan tag 1.
NTex
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: