cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1883
Views
0
Helpful
2
Replies

SG200-08 won't boot anymore

Hi,

When I came back home today I saw that my SG200-08 switch did not look fine.

Basically, the system LED of the switch keeps blinking and end devices connected just don't have any network.

I tried to reset the switch with the "reset" button (with a paper clip) the system LED was orange during just a second and then continue to blink.

What is wrong with the switch?

Is there a way to flash a new firmware and/or to delete the configuration file?

Thank you for your help.

2 Replies 2

jasbryan
Level 6
Level 6

Guillaume Mazoyer,

If the system light is blinking green means it didn't pull a DHCP address from DHCP server.static assign your pc ip address to 192.168.1.20 255.255.255.0 and try and get into web gui @ 192.168.1.254. If this fails try hold the reset button again for about 30-45 seconds. If you still can't access the switch then call SBSC @ 1-866-606-1866 to open a support case.

Jasbryan

Holding the reset button a little more did the trick.

Thank you for quick answer.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X