Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SG200-08 won't boot anymore

Hi,

When I came back home today I saw that my SG200-08 switch did not look fine.

Basically, the system LED of the switch keeps blinking and end devices connected just don't have any network.

I tried to reset the switch with the "reset" button (with a paper clip) the system LED was orange during just a second and then continue to blink.

What is wrong with the switch?

Is there a way to flash a new firmware and/or to delete the configuration file?

Thank you for your help.

2 REPLIES
Silver

SG200-08 won't boot anymore

Guillaume Mazoyer,

If the system light is blinking green means it didn't pull a DHCP address from DHCP server.static assign your pc ip address to 192.168.1.20 255.255.255.0 and try and get into web gui @ 192.168.1.254. If this fails try hold the reset button again for about 30-45 seconds. If you still can't access the switch then call SBSC @ 1-866-606-1866 to open a support case.

Jasbryan

New Member

SG200-08 won't boot anymore

Holding the reset button a little more did the trick.

Thank you for quick answer.

956
Views
0
Helpful
2
Replies
CreatePlease login to create content