I have been testing all possible issues with this sg200-08p
I have 3 PoE cameras that are connected to the switch. Only ports 1&2 are up and are sending power to the cameras. I tested to see if the camera was the problem but when I plugged camera 3 into either port 1 or 2 it started up just fine. I've turned off green ethernet on all the ports as well.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...