SG200-08P (SLM2008PT-EU) support for Te...

Cisco Support Community

Community Member

‎11-27-2013 03:20 AM

Dear Team,

Does SG200-08P (SLM2008PT-EU) support Telnet, CLI and CDP and in which SW release?

Release notes and admin guides are not so clear about this.

Thanks in advance,

Nenad

Labels:

Small Business Switches

2 REPLIES

Green

‎11-27-2013 08:39 AM

Hi Nesked, the switch does not support telnet or CLI.

CDP is supported, you should be using the latest software releases.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Community Member

‎04-27-2014 12:07 PM

Hi Nenad,

The switch itself does not support CDP, but it will forward CDP packets to connected devices that support CDP.

Latest Documents

Cannot Add a New Switch to an Existing Stack

Created by smallbusiness on 04-25-2018 10:59 AM

Article ID:5811 Cannot Add a New Switch to an Existing Stack Introduction Stacking is a network solution that connects two or more switches on top of one another and configuring them as one device. The switches in a stack function as a single switch... view more

Configure the PNP Settings on a Switch

Created by smallbusiness on 04-24-2018 01:59 PM

Article ID:5810 Configure the PNP Settings on a Switch Objective The installation of new networking devices or replacement of devices can be expensive, time-consuming, and error-prone when performed manually. Typically, new devices are first sent to... view more

SG350X, Sx550X: RSPAN Mirrored Packet Loss when Forwarding

Created by smallbusiness on 04-18-2018 09:59 AM

Article ID:5808 SG350X, Sx550X: RSPAN Mirrored Packet Loss when Forwarding Date Identified February 12, 2017 Date Resolved N/A Products Affected Model Firmware Version SG350X, Sx550X 2.2.0.x ... view more