Hey guys I'm having a issue with my switch syncing with ntp servers. I have it enabled and I configured the SNTP servers ( time-a.timefreq.bldrdoc.gov, time-a.nist.gov just to name a few) but they are showing down in the status. I have DNS configured and those hostnames are showing up in the host mapping as good and is pulling the ip address. Not to sure why it's not working....any thoughts?
You might try to check if you have DNS server and default gateway configure for the switch itself. You can try to see if ping to the NTP server from the switch (Diagnostic utility) is sent correctly. And if above tests results are positive I would try to get packet capture of the uplink port and verify if the NTP packets are sent from the switch.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...