Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SG200-26P not powering three access points.

Hello,

 

I just purchased a Cisco SG200-26P to power three Ubiquiti UAP-LR-3 UniFi AP that are going in a new small network. I added the three AP’s to port 1, 2, and 3 and they are not powering up off the POE switch. I got into the switch and I don’t see anything that stands out for them to not power up. The AP’s work powered up with POE injectors. 

 

Thanks,

Minitrucker007

  • Small Business Switches
3 REPLIES
New Member

It looks like the AP's are

It looks like the AP's are 24Volt and the switch is 48V. Is there a way to turn down the Voltage on the port?

Hi Minitrucker,SG200-26P is

Hi Minitrucker,

SG200-26P is 802.3af compliant but from what I manage to read Ubiquiti UAP-LR is not 802.3af/at compliant, correct me if I am wrong as I did not really find the datasheet for your specific AP.  This would mean that the AP would need the injector or specific switch rather than any. As it uses non standard PoE.

 

Regards,

Aleksandra

New Member

Your right there not. I am

Your right there not. I am going to send these UAP-LR AP's back and upgrade them to the big brothers. Thanks for the help.

302
Views
0
Helpful
3
Replies