Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

SG200-50 LACP on port 49 and 50

Hello

I used LACP on port 49 and 50.

After upgrade firmware from 1.0.0.19 to 1.1.2.0 my LAG1 stay down...all port member stay down, port link is up but LAG stay down...

I testtu delete and reconfigure LAG1 but nothing work...

Everyone's tags (5)
3 REPLIES
Bronze

SG200-50 LACP on port 49 and 50

Hello DSI

What is the port 49 and 50 connecting to? What is the configuration on that device?

Cisco Small Business Support Center

Randy Manthey

CCNA, CCNA - Security

New Member

SG200-50 LACP on port 49 and 50

My settings are on SG200-51 Number 1:

Port Management / Port Settings :
Interface  | Port Type            | Status Port | Speed Duplex | Mode | LAG
GE49       | 1000M-ComboC | Up               | 1000M             | Full    | 1
GE50       | 1000M-ComboC | Up               | 1000M             | Full    | 1

In Port Management / Link Aggregation / LAG Management :

LAG   | Name           | LACP      | Link State      | Active member  |  Standby Member

LAG1 | Networks1   | Enabled   | Link Down    |                            | GE49, GE50

In Port Management / Link Aggregation / LAG Settings :

Entry N° |  LAG | Descritpion | type | status | auto négotiontion| speed | flow Control

     1       | LAG1 |Networks1   |         | Down |                            |             |

In Port Management / Link Aggregation / LACP :

Entry No. | Port    | Port Priority | LACP Timeout

    49        |GE49   |1                    |Long

    50        | GE50  |1                    |Long

I have this problème with some SG200.

In case 1 with a other SG200 with the same configuration for LAG

In case 2 wiith Catayst 2960S with LAG configuration.

But before fireware upgrade on SG200 all work fine!

Bronze

SG200-50 LACP on port 49 and 50

DSI,

I would recommend calling the 1866-606-1866 support number and creating a case, so we can gather further information.

thanks

Cisco Small Business Support Center

Randy Manthey

CCNA, CCNA - Security

2200
Views
0
Helpful
3
Replies
CreatePlease to create content