sg200 firmware 18.104.22.168 - how do you config new dhcp4 server feature?
The release notes for the 22.214.171.124 firmware (7/29/13) notes major feature added is "dhcp4 server" (page 8)
I've read the the administrator manual for this release (78-21139) and can not figure out how to configure the dhcp4 server. I'm not even sure I'm understanding the manual correctly. Starting on page 60 it dicusses uploading a dhcp server config file. I'm not aure that concerns the new dhcp4 server function.
Does anyone know how to set up and configure the new dhcp4 server function in the sg200 switches. Thank you for any help.
sg200 firmware 126.96.36.199 - how do you config new dhcp4 server feat
Assuming it is the same SG300 and 500 that I have worked on you find DHCP server settings in the GUI under IP Configuration > IPv4 Management > DHCP Server. One interesting thing I noticed is that you can assign dhcp scopes per VLAN by just choosing a range and subnet that matches your VLAN. There is no specific config connecting the scope to the VLAN but it "just works".
-- please remember to rate and mark answered helpful posts --
Since I downloaded from the sg200-26 firmware page, I assumed the release notes were for sg200 switches. After reading your post, I note the release notes are for 200, 300 and 500 switches. Page 8 of the release notes added dhcpv4 server feature. I did think it strange a level 2 switch (mac based) would have a level 3 (ip based) feature. I'm hoping this is included in the sg200 switches.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...