I'm having an issue getting my SG300-10 into Layer-3 mode. I had it in Layer-3 mode under version 1.3.7.18, performed a factory reset by holding down the hard-reset button for 10 seconds. Updated boot loader to 1.3.5.06 and SW Firmware to 1.4.0.88.
switchc4f42e#sh ver
SW version 1.4.0.88 ( date 06-Aug-2014 time 16:55:55 )
Boot version 1.3.5.06 ( date 21-Jul-2013 time 15:12:10 )
HW version V02
Now I cannot find the option to switch it back into Layer-3 mode. There is no "menu" option at the console (serial).
switchc4f42e#
boot Boot Commands
clear Reset functions
clock Manage the system clock
configure Enter configuration mode
copy Copy from one file to another
crypto Cryptographic commands
debug-mode Exit from the EXEC to debug mode
delete Delete a file from the flash file system
dir Display the list of files on the flash file system
disable Disable privileged commands
dot1x 802.1x EXEC commands
errdisable Err-Disable shutdown commands.
exit Exit from the EXEC
green-ethernet Green ethernet commands
help Description of the interactive help system
ip Global IP configuration commands
login Exit from the EXEC and Log in
macro Ports macros
more Display a file
no Negate command
ping Send echo messages.
reload Halt and perform a cold restart
rename Rename a file
renew Renew DHCP address
resume Resume telnet session.
set Set System Parameters
show Show running system information
telnet Open telnet session.
terminal Set current session functions
test diagnose
traceroute Discover the routes to destination.
write Write running configuration to memory or terminal
switchc4f42e#menu
% Unrecognized command
switchc4f42e#
What do I need to do to get this switch back into Layer-3 mode?
