I have 8 SG300 switches in various buildings. I have been able to regularly access the switches via HTTP from an external network. On occasion a switch that had been communicating well will stop responding to HTTP requests. It has happened to several three different switches so far. I can ping the switch and the switch is passing traffic fine, but I cannot log in to reconfigure the switch. Even if I connect directly to the switch through a computer on the network I still cannot talk via HTTP.
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...