I have one question regarding switch sg300-10. How can i check current interface utilization in bits/second, please? If I use show int counters I can only see number of unicast, broadcast and multicast packets....plus total packets. But there is no info regarding input and output rate for particular interface (like in original IOS when using show interface command). Is there any way how to solve this,please?
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...