Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SG300-10 IP-Helper

Hello everyone,

I'm trying to configure ip-helper on my SG300-10 but can't figure out how to do it. I've been using these steps to configure mine but i run into a stop at "Device(config-if)# ip helper-address 172.16.1.2" Here i don't have the command ip helper-address.

 

Is it that my device can't use ip helper? Or did i miss some other configuration in order to be able to configure iphelper?

 

Thanks in advance :-) 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi follow this guide to get

3 REPLIES
VIP Purple

Hi follow this guide to get

New Member

I was looking for the same

I was looking for the same guide, thank you for your help !

New Member

This is just what i needed,

This is just what i needed, thanks alot!

223
Views
0
Helpful
3
Replies
CreatePlease to create content