Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SG300-10 show lldp details causes reboot

Running the newest firmware available

$ show version

SW version    1.1.2.0 ( date  12-Nov-2011 time  23:34:26 )

Boot version    1.0.0.4 ( date  08-Apr-2010 time  16:37:57 )

HW version    V01

This is how I can cause the reboot to happen every time. Please advise.

$ show lldp neighbors GE 10

Device ID: <mac address>

Port ID: 22

Capabilities: Bridge

System Name: av-wwp

System description: LightningEdge (tm) LE-311 Access Concentrator

Port description: Fast Ethernet Port

Management Address: <ip address>

Management Address: <ip address>

Time To Live: 96

802.3 MAC/PHY Configuration/Status

Auto-negotiation support: Supported

Auto-negotiation status: Enabled

Auto-negotiation Advertised Capabilities: 1000BASE-T full duplex

Operational MAU type: Unknown   <-- loose connection here and switch goes for a reboot.

Thanks,

Rob

  • Small Business Switches
1 REPLY

SG300-10 show lldp details causes reboot

Hi rob,

Sounds like a case for SBSC.

But you have two software images in the switch, for the purpose of going back to a more stable release.  I guess that was the intention of having two software loads on a switch.

But please open a case with SBSC so this issue can be investigated.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

Sorry for this inconvenience and thank you for your purchase.

Regards Dave

739
Views
0
Helpful
1
Replies