Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SG300-10 switch commands not working

Hey guys

New to all this so be kind

I have an SG300-10 switch and have connected to the switch by telent and SSH, but when I run commands like 'enable' is tells me 'Unrecognized command'

The firmware is Version 1.3.0.62, I checked it looks like a new version is available, do I need to upgrade the firmware? If so are there any steps I need to follow to upgrade the firmware without bricking the switch?

EDIT: Ok so I tried the command conf t which worked, why does enable not work? Is it because the CLI is not IOS?

Thanks

Matt

3 REPLIES
Community Member

SG300-10 switch commands not working

Yep, the IOS commands have different levels.  You'll need to use the CLI command specific to the SG series since there are many differences.

Community Member

SG300-10 switch commands not working

Thanks, do you know where I can get a guide with the commands?

Community Member

SG300-10 switch commands not working

http://www.cisco.com/en/US/docs/switches/lan/csbms/sf30x_sg30x/administration_guide/CLI_300_1_2_9.pdf

This CLI does show the "enable" command too but maybe telnet sessions on these SG switches skip straight to level 15 if that's the privledge level of the user. 

696
Views
0
Helpful
3
Replies
CreatePlease to create content