03-13-2014 08:08 PM
Hi,
My SG300-10P cannot bootup suddenly, LED status shows at attached photo.
System LED keeps blinking, G9 LINK/ACT & GIGABIT, G10 LINK/ACT keeps on even no connection.
DB9 console port no respond.
anyone knows whats happened? Is it borken?
Thanks
Alan
03-14-2014 07:44 AM
Hi AC, if the console does not respond th only other thing you may try to do is factory default the unit holding reset for about 35 seconds or so. If this does not recover it and the console absolutely does not work then the switch is effectively dead.
03-18-2014 10:50 PM
Hi Tom,
Thanks for your reply. Seems i have to say good bye to my switch, as i do tried to reset it to factory default but fail.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: