Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
AC
New Member

SG300-10P cannot boot up

Hi,

 

My SG300-10P cannot bootup suddenly, LED status shows at attached photo.

System LED keeps blinking, G9 LINK/ACT & GIGABIT, G10 LINK/ACT keeps on even no connection.

DB9 console port no respond.

anyone knows whats happened? Is it borken?

 

Thanks

Alan

2 REPLIES
Green

Hi AC, if the console does

Hi AC, if the console does not respond th only other thing you may try to do is factory default the unit holding reset for about 35 seconds or so. If this does not recover it and the console absolutely does not work then the switch is effectively dead.

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
AC
New Member

Hi Tom,Thanks for your reply.

Hi Tom,

Thanks for your reply. Seems i have to say good bye to my switch, as i do tried to reset it to factory default but fail.

268
Views
0
Helpful
2
Replies
CreatePlease to create content