SG300 10p - disconnects after trying to apply ip to vlans
Its really my first foray into a Cisco SMB device - have been trying to configure the SG300 10P for a few days now but to no avail. I have also upgraded to latest firmware 184.108.40.206 and now downgraded back to 220.127.116.11 and the problem resides.
I am simply trying to create vlan and assign an IP to it (I am in L3 mode) - however each time I go to apply the IP - I lose connection and then I have to unplug the device again to connect back. For example if I try to implement the below - courtesy of Tom Watts at the point where I am creating vlan 200 and assigning the Ip address once I press enter - it will lose connection. The same happens within the gui. Any ideas where I am going wrong.
interface vlan 1
ip address 192.168.100.137 255.255.255.0
no ip address dhcp
interface vlan 200
ip address 192.168.99.1 255.255.255.0
ip dhcp server
ip dhcp pool network test
address low 192.168.99.1 high 192.168.99.254 255.255.255.0
Also separately I can't get the DHCP server to issue any Ip addresses to clients so I am having manually assign addresses on client devices.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...