i have installed SG300-10SFP switch in one customer site, port g1-g9 is for customers and g10 for uplink to Metropolitan network
after installation, all working fine, in port g10 i have installed SFP CWDM with DDI (diagnostics) all data like Temp, signal etc... switch displays correctly, after 60days i can check DDI info, but now switch displays only "N/A" value
i can try reboot, but same value in WEB or CLI, in port status is all OK port is connected
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...