I've the SG300 configured in L3 mode, with 5 VLANs each having its own DHCP pool. Everything works as expected. However, my QNAP TS419-PII is not able to pull IP address on both of it's NICs. Note that if I move the DHCP to my RV042 router, IPs are asigned properly.
Is anyone aware of this issue with SG300? I have FW 184.108.40.206 on the switch.
Is there some configuration required in terms of DHCP options?
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...