I updated the firmware to the latest version. Reset the switch after the bios update. The only problem I have now is none of the gi ports are active. I can get into the CLI. What command do I need to activate all the ports. It says links are down.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...