I bought a security camera system that uses a windows 7 pro based dvr, the system came with a cisco sg300 28p switch. I know my problem is i am new at this stuff but when i went to set every thing up the dvr will not recognize the switch it keeps turning the network manager on and off, ami missing a part?
Please help i dont know what to do
Hi J, I guess I don't understand the problem. The DVR does not recognize the switch? Does it mean there is no connectivity? Does the port light turn on the switch? If the network management keeps turning on/off it sounds more an issue with the DVR. You can try moving to different ports on that switch but I suspect the problem would follow. You may want to contact the Secutiy company for support on the DVR.
Please mark answered for helpful posts
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: