Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SG300 feature set in Layer3 mode

Hi,

I browsed through archives and googled some about the difference between Layer2 mode and Layer3 mode. But all are just saying to make inter-vlan routing work, or configure multiple vlan interfaces, you need to change it from Layer2(default?) to Layer3 mode.

My questions are:

Q1) Are there any features lost when I changed the mode from Layer2 to Layer3? Are all features available in Layer2 mode there in Layer3 mode?

Q2) If the answer to Q1) is yes, what's the reason to have Layer2 mode and it is the default mode? Is this only for performance/memory concerns?

Thanks,

Toshi

3 REPLIES
New Member

SG300 feature set in Layer3 mode

I meant...

Q2) If the answer to Q1) is no,...

Green

SG300 feature set in Layer3 mode

Please see this post.

https://supportforums.cisco.com/thread/2238659

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
New Member

SG300 feature set in Layer3 mode

Thanks! That's what I was looking for.

235
Views
0
Helpful
3
Replies
CreatePlease login to create content