SG300 not authenticated in Configuration Assistant
Hello, I am fairly new to the Cisco Switches and just recently received an SG300-28, I have changed it to L3 and setup the IP along with 3 LAGS and everything is working great, I am currently setting up 3 SG300-10P that will connect to the 28 and was hoping to use the Configuration Assistant but the switches will not Authenticate. It eventually finds the main switch but always asks for as username and password for the "REALM ADMIN" which I am not sure what that is and then it says it can't Authenticate. I have enabled Telnet and SSH but I am thinking I may have something set wrong or missed something. I can Telnet into the switch and see the config and change the config but still no luck.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...