SG300 not authenticated in Configuration Assistant
I am new to the SG300 series switch and am having an issue with the SG300-28 and the configuration assistant. I have changed the IP, set up 3 devices with LAG and setup Telnet to work on the box. But in the Configuration Assistant the box will not seem to Authenticate, it always fails. when I try to add the box it asks for a username and password to the "REALM ADMIN", not sure what that is and I think that is what is causing the box not to authenticate. Everything else on the box is default for the most part.
Any help would be appreciated and thank you in advance.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...