Hi there, We have several SG300 series switches in our LAN. Yesterday, I was patching one to the actual firmware. When booting it up, I found a feature in the telnet session that promises me to set a stacking ID. I didn't find any info in the cli manual or somewhere else online.
What are the features and how can I access them. It would be great to setup all together with one script... Thanks in advance,
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
On a technical level, Cisco 300 Series is far superior to the HP 1910
and 2530 products. This document provides evidence that Cisco has >100
features not supported by the HP platforms. Check this out and decide
for yourselves. Notes (2/5/2014):- Informati...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: