I am setting up a configuration using a centralised logging server for about 10 sg300 switches.
Switches are all configured using sntp as a time source. Switches show the correct clock time at status page. Timezone is defined with UTC+1, acronym CET. There is a recurring time for summer time defined. We are still in summer time until last Sunday this month. Using summer time is actived in the GUI.
Syslog-Server is also using NTP. Time is also correctly applied there.
Log entries from switches appear where I expected them, BUT showing up with UTC+1, not UTC+1+60 minutes since we are still in this time slot.
Article ID:4006 Configure Secure Shell (SSH) Server Authentication
Settings on a Switch Objective Secure Shell (SSH) is a protocol that
provides a secure remote connection to specific network devices. This
connection provides functionality that is similar...
Article ID:4982 Access an SMB Switch CLI using SSH or Telnet Objective
The Cisco Small Business Managed Switches can be remotely accessed and
configured through the Command Line Interface (CLI). Accessing the CLI
allows commands to be entered in a termina...
Article ID:5735 Convert Configuration Files using the Configuration
Migration Tool on Cisco Small Business Switches Introduction The Cisco
Configuration Migration Tool allows you to convert configuration files
from previous generation of Cisco Small Busin...