Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

SG300 Vlan IP-Helper Address issues

hi,

I am trying to set a ip-helper address on my sg300 though getting the following.

DNSWITCH01#configure

DNSWITCH01(config)#interface vlan2

DNSWITCH01(config-if)#ip helper-address 192.168.1.1

% missing mandatory parameter

DNSWITCH01(config-if)#DNSWITCH01#

DHCP server is server 2008 R2 and the range is active for that vlan and can route to vlan and devices set statically fine

1 REPLY
Green

SG300 Vlan IP-Helper Address issues

Hi Konrad, DHCP cannot be used for IP helper since the switch has a DHCP-RELAY service.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
562
Views
0
Helpful
1
Replies
CreatePlease to create content