I have a couple of questions hoping someone could tell me how to make it work:
The following situation in my home right now:
1) Fiber coming into my home (other side is a Cisco 2911 router with both internet and my own ip adresses)
This is right now directly connected to the SG300 switch (L2) i have at home
2) I however also have a normal 100mbit cable connection at home, a Cisco EPC3925 modem/router.
I was thinking of, in some way maybe making a local network where it could either use both connections or use one as backup, when the other goes down for within my home. Ofc all devices on my local LAN need to be able to connect to the internet.
Is there a way at all to make this work? And if so, how do i need to configure the SG300 (maybe enable DHCP/L3?) and do i then need to disable DHCP on the 2911 and/or the cable router/modem?
If you are wanting to use two different connections one method would be to have the connections come into the switch on two different VLANs and then have those two different VLANs each go to a different router. When one connection goes down you could connect to the next one.
If you are wanting to use them on the same connection you could use DualWAN router.
Sx550X, Sx350X, Sx250: PSE will Supply Power to Catalyst PSE Ports
May 31, 2016
June 5, 2017
Configure Remote Network Monitoring (RMON) Events Control Settings on a Switch through the Command Line Interface (CLI)
Remote Network Monitoring (RMON) was developed by the Internet Engineering Task Force (IETF) to support...