We've just implemented one Cisco SG500-28 on our infrastucture. I need to monitor this Switch, but the switch doesn't matchs with Cisco Catalyst switchs mibs.
I downloaded the SG500 mib (here) , but don't find OIDs for CPU utilization and environmentals sensors (Temps, Fans, Psus). I have no return when I do SNMPWalk for OIDS in mib "CISCOSBCpuCounters.mib" and "CISCOSB_env_mib.mib"
Does anobody knows these OIDS on the SG500 switchs ?
Introduction:Topology Diagram:Configuration Overview:Related
Information: Introduction: This document describes how to connect SG300
with Catalyst switch via STP. Spanning Tree Protocol (STP) is a Layer 2
protocol that runs on mainly on switches. The spec...
The Sx500 Series Stackable Switches offers different port features. You
can add security to a port, make the port more energy efficient, map a
VLAN to a port, make a port available or not to a specific network
portion, and so forth. The next set of articl...
Recently, HP Networking published a blog post attempting to counter the
favorable third party Miercom report on our Cisco® 200 and 300 Series
Smart and Managed switches: