Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

SG500-28 Ports Features

Hello,

I would like to know if its possible to configure a SG500-28 with the S1 and S2 as stack ports and S3 and S4 as uplinks ports @1G?

I need 2 uplikns (SFP) and 1 stack port (1000baseT).

Thanks.Capture.jpg

1 REPLY
Bronze

SG500-28 Ports Features

Dear Ricardo,

Thank you for reaching the Small Business Support Community.

S1 and S2 are stack ports by default. You can manually reconfigure S1/S2 and S3/S4 as network ports or stack ports on Native Stacking mode. S3/S4 port speed, as network ports, are capable to run at 1G, as long as you use the correct cable type, please refer to the admin guide, page 76, for details;

http://www.cisco.com/en/US/docs/switches/lan/csbms/Sx500/administration_guide/500_Series_Admin_Guide.pdf

I hope this answers your question and please do not hesitate to reach me back if there is any further assistance I may help you with.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
762
Views
0
Helpful
1
Replies
CreatePlease login to create content