Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

SG500 auto voice VLAN question about native VLAN

I have been installing SG300 and SG500 switches and using the auto voice vlan feature by simply changing voice vlan to 100 and using vlan 1 for default and data.  I normally put the switch in L3 mode and make an access porteach for my IP PBX (vlan 100)  and one to connect to existing data network (vlan 1). Then I make a static route in customers default gateway to route back to vlan 100 and everything works nicely for most installs. 

On my last install I decided to try to change the default vlan 1 to vlan 10 and go with 10 for data and 100 for voice.  The problem I ran into was that the auto generated config on my phone switchports still use vlan 1 as native vlan.  I am trying to find a way to still use auto vlan and get the desired native vlan without having to make manual config changes.

Should this be possible?

Thanks in advance.

-- please remember to rate and mark answered helpful posts --
1 ACCEPTED SOLUTION

Accepted Solutions
Green

SG500 auto voice VLAN question about native VLAN

Hi Brandon, you need to modify the macro from native vlan 1 to vlan 10.

Check out this topic how to modify the macro

https://supportforums.cisco.com/thread/2177613

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/
2 REPLIES
Green

SG500 auto voice VLAN question about native VLAN

Hi Brandon, you need to modify the macro from native vlan 1 to vlan 10.

Check out this topic how to modify the macro

https://supportforums.cisco.com/thread/2177613

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

SG500 auto voice VLAN question about native VLAN

BINGO!  thanks for the quick response.

-- please remember to rate and mark answered helpful posts --
1188
Views
0
Helpful
2
Replies
CreatePlease to create content