Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SG500X: CLI command to show SFP type ? (like sh int status on IOS switches)

Hi

is there a CLI command to display the SFP model/type inserted in ports ?

on ios switches, there are several commands to show this information

i have some SFPH10GB-CU3M and SFP-10G-SR and want to see from remote in what slot they are inserted.

regards

10 REPLIES
New Member

the show interface

the show interface capabilities command will show you the SFP that is installed

r_h, I see no such command on

r_h, I see no such command on this switch..

-- please remember to rate and mark answered helpful posts --
New Member

on the SG500X-24 running 1.3

on the SG500X-24 running 1.3.7.18 there's no "sh int capabilities"

Silver

Hello,You should be able to

Hello,

You should be able to run a show inventory <port> and get a description of the SFP back, similair to the example below:


switchxxxxxx #show inventory gigabitethernet 2/1/49
NAME: "GigabitEthernet2/1/49", DESCR: "1000M base-LX Mini-GBIC SFP Transceiver"
PID: MGBLX1,VID: V01, SN: AGC1525UR7G
 

There is also the show fiber-port optical-transceiver command, but that is more of a diagnostic for when the fiber is connected, it doesn't show the SFPs model number like the above command does.

 

Hope that helps,

Christopher Ebert - Advanced Network Support Engineer

Cisco Small Business Support Center

I just confirmed this command

I just confirmed this command works, but would point out that the command does not exist on some older firmware.  It does exist on 1.3.7.18.

-- please remember to rate and mark answered helpful posts --
New Member

Hiit does not work for int

Hi

it does not work for int te1/1 and te1/2 when using SFPH10GB-CU3M.

running software 1.3.7.18 (boot 1.3.7.1) on SG500X

Silver

Hello,I can confirm that this

Hello,

I can confirm that this command does not seem to work for the SFPH10GB-CU3M.  I am not sure if this is by design since those are proprietary stack cables or just an oversight.  I went ahead and raised the issue, when I hear back from L2 I will update here as well.

Thank you,

Christopher Ebert - Advanced Network Support Engineer

Cisco Small Business Support Center

*please rate helpful posts*

New Member

HiThe SFP-H10GB-CU3M and the

Hi

The SFP-H10GB-CU3M and the SFP-10G-SR are supported by the SG500X platform since they are listed under Accessories (Stacking Options and Modules).

Would be nice when we could read out this data.

regards

New Member

seems this isn't fixed with

seems this isn't fixed with SW 1.4.7.6 yet right?

New Member

Hi, try these 2 commands :

Hi, try these 2 commands :

* show inventory (if 3rd party module, maybe nothing will be shown, if Cisco module, you'll get info for sure)

* show fiber-ports optical-transceiver (info about performance of optical fiber module)

N.B. : Update to the last firmware/ software and the bootcode

May help you. Bye.

10381
Views
5
Helpful
10
Replies