sge2010p switch with polycom 335 how to VLAN or voip

[coyote8921029]

Hello guys,

We just purchased one of Linksys SGE2010P for upcoming plan for VOIP in our office.

And ony 1 port per each cubicle is available through gigabit wiring.

So people will hookup this ip phone to their port and then PC.

Using L2 switch, there is no way to separate voice and data through VLAN and this is why we purchased SGE2010P which is L3 fuctional switch.

With this L3 switch - SGE2010P - what would be a best practise to make a voip to work?

Sorry for very little information but will appreciate any advice,

Thanks

Charlie

[David Carr]

Are you looking to setup vlans on the switch or do layer three switching on the sge2010?  If layer three, you could do the vlans on the switch and do a default route to the router.  Then setup a route back from the router to the switch for the networks included in the vlans.

If in layer 2, just create the vlans on the switch and configure the switch as a trunk with data and voice on the trunk.