We have bought 1 of SLM2048 for our office to upgrade two old switches to one 1GB network. I wonder what is the reason that eveery now and then the trafic slows down to about 10 to 20 kB/s and I need to reboot the switch to get it working again. it is going on in different intervals some times twice a week somtimes twice a day (as today) .
Does enybody have idea what causes it. Is it overheating or is it some firmware issue? It is realy anoing. And Im now getting blamed for spending £600 for the switch which does not do any good.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...