Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SLM2008 firmware upgrade 2.0.0.10

I have upgrade to 2.0.0.10 with the upgrade reported as successful. Since the upgrade I have not been able to access the web interface. I have cleared the browser cache, tried alternate browsers and different hosts as well as restarting and reset the switch.

A typical connection request lasts about 15/20 seconds with browser status reported "Done" and a blank page presented

Short of performing a factory reset are there any suggestions?

1 REPLY

Re: SLM2008 firmware upgrade 2.0.0.10

Hi feeks,

I guess you have the problem resolved by now.

But the release notes mentions a few things regarding what you may notice after the upgrade, click on the link below;

release notes

regards Dave

3968
Views
0
Helpful
1
Replies
CreatePlease to create content