Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SLM2008 VLAN

Hi, VLAN newbie here!

I need to setup a VLAN using a SLM2008 and connect it to our Fortigate Internet Firewall.  I'm doing this to segregate the SLM2008 traffic from the main network which is already connected to the firewall.  I have created VLAN #200 in the SLM2008.  I have read all the SLM2008 documentation and spent quite a lot of time on these forums but can't seem to get this working.

Questions:

1. The firewall is seen on the network as another multi-port hub, so does this mean that the SLM2008 must be connected to it via a VLAN trunk link?

2. On this forum someone said you must use Port 1 of the SLM2008 if you want to do trunking?  True?

3. If #2 is correct, then how do you setup port 1 as a trunk?  There is no trunk option in the web gui.

Thanks in advance!

Marty

Everyone's tags (3)
1 REPLY
Community Member

Re: SLM2008 VLAN

I finally found the answer by discovering this page.  The Cisco documenation is incomplete

on setting up the SLM2008 as a VLAN trunk.  Follows the steps given here:

http://www.jarmanator.net/kb/slm2008vlan.htm

Marty

2549
Views
0
Helpful
1
Replies
CreatePlease to create content